|
|
|
|
|
|
|
|
|
This item does NOT ship for free |
Shipping charges will apply to this item. If you place your order now we will call with the shipping rate. If the rate is approved by you we will charge you the additional shipping. If the rate is NOT approved by you then we will cancel your order. If you do not wish to place your order now you can enter in the quantity you wish to order and your zip code in the Q&A section below and we will respond with a quote. |
|
|
|
Bottle Bracket & Tube Clamp Together
|
|
|
WARNING: Laws concerning this product vary from state/province to state/province. Your state/province may prohibit its use on public roads or restrict its use to novelty, show use, off-road areas, or race facility areas only. In some states/provinces off-road uses are also prohibited. The manufacturer and retailer assume no responsibility for any use or application of this product in violation of any applicable law. Before installing this product, please check your state/provincial and local/municipal laws and regulations. |
|
The Q&A on this Product |
|
|
QUESTION: Can this Bracket by used to Mount the bottle in the Swing arm under the Subframe right next to the wheel? |
ANSWER: You will need a vertical tab to bolt the bracket. |
|
QUESTION: I have a 01 GSXR 600 and i wanna no were would be a good place to put it, i want it to be alittle hiden, in my town its not somthen u want to show of to the local law enforcment, and what size bottle would be the best? |
ANSWER: The biggest bottle you can fit is the best. It's hard to say where to mount it. |
|
QUESTION: Hello,
The hole to mount it to the frame is 4 inches? I thought 1 in. or 1 1/2 inches. I have never heard of a frame that had 4.3 in. diameter. Are you sure that's not the bottle diameter?
|
ANSWER: There is no hole to mount to the frame. That is the bottle diameter. |
|
QUESTION: How big is the mounting hole on this clamp? |
ANSWER: 4.375" |
|
QUESTION: do you stock these brackets or order them through MPS.com? i need to get a 2.5lb bracket shipped to SC as soon as possible, and since MPS is closed till the 21st of November, i was trying to see if i can just order from you but only if you have them in stock right now. Thanks. |
ANSWER: |
|
QUESTION: does this come with all mounting hardware? i want to mount it to the tail section of my 04 636 on the left side (opposite the exhaust) and wanted to make sure i have everything i need. thanks |
ANSWER: No bottle mounting hardware is included. |
|
QUESTION: is this mount for the 1lb bottle? and what is the right sized bittle bracket tube mount? |
ANSWER: No, depends on the tube size you are clamping to. |
|
|
|
Ask your question here: |
|
Your email (so we can send you the answer): |
|
|
|